Hydrocyclone filter sand separator cyclone sand separator 3/4 "M

Hydrocyclone filter sand separator cyclone sand separator 3/4 "M

MCICL3/4FMPN10

New product

Hydrocyclone sand filter AGREN removes up to 90% of sand and particles greater than 75 μ present in the water of your system.

  • Hydrocyclone flow rate: 3.6 m³ / h; 1 lt / sec
  • Connections: 3/4 "male threaded
  • Sand collection tank: 1 "male thread
  • Maximum operating pressure: 10 bar
  • Resistant and long-lasting thanks to the hot-dip galvanized steel body

More details

Available

Warning: Last items in stock!

204,92 €

Shipping cost

There is no carrier available to delivery the product to your location

Destination

Valutazione clienti

(4/5)
1 voto(i) - 1 recensione(i)
Mostra tutte le valutazioni
Tip
Contact us  
If you make big orders or if you are a reseller or an importer ask us a quote

Data sheet

Thread3/4" male

More info

HOW TO CHOOSE THE HYDROCYCLONE FOR YOUR SYSTEM

To choose the right hydrocyclone you need to know the pressure and flow rate of the system and the diameter of your pipe .

  • The 3/4 "hydrocyclone is the right choice if your system has: at least 3/4 inch pipes, your pump a flow rate of at least 3.6 m³ / h (i.e. 1 l / sec or 60 l / min) and a pressure greater than or equal to 2 bar.
  • If you have a pressure of less than 2 bar you can take a 1/2 "hydrocyclone and increase the pressure using a reduction between the tubing and the 1/2" hydrocyclone.
  • If, on the other hand, you have a system with pipes and a greater flow rate, you can consider the idea of a larger hydrocyclone (1 ", 1" 1/4, ...).

INSTALLATION OF THE HYDROCYCLONE

The hydrocyclone must be connected at the outlet to your pump.

If the diameter of the pipe is equal to the hydrocyclone just use a 20x3 / 4 "female fitting. If the diameter of the pipe is greater than 3/4" use a reduction.

A female 1 "ball drain valve that you find among our accessories must be connected to the sand collection tank. To obtain an automatic sand discharge effect, it is possible to leave the tank drain valve open by about 10 degrees, thus allowing it to escape. automatic sandblasting. hydrocyclone particle discharge valve
Finally, connect a 1/4 "M pressure gauge with stainless steel case and glycerine in the 1/4" female coupling located at the inlet of the hydrocyclone. hydrocyclone pressure gauge



WHY BUY A HYDROCYCLONE

The AGREN separator cyclone is suitable for both domestic , agricultural and industrial use and is essential to remove sand and other particles present in the water by separating up to 90% of sand and particles with a grain size greater than 75 μ ( to remove particles below this particle size it is recommended to connect a mesh filter at the outlet of the hydrocyclone )

Advantages for home use :

  • you extend the life of your plumbing system by preventing them from messing around: pipes, tap diffusers, boilers, dishwashers and all appliances that use water.

Advantages for irrigation :

  • If you draw water from rivers, wells or lakes to irrigate, the particles present can damage or reduce the efficiency of your irrigation system by clogging sprinklers, dripping wings, valves and heads.



OPERATION OF THE HYDROCYCLONE

the centrifugal force of the tangential inlet water separates the sand that slides on the filter wall, precipitating downwards where it is collected in the tank below. To empty the tank, simply open the drain valve. (valve not included).

The centrifugal speed depends on the flow rate and the pressure. The greater the flow rate or pressure of the liquid, the greater the centrifugal force, the more efficient the separator will be.



THE RELIABILITY OF GALVANIZED STEEL

Unlike the products of other brands which are simply painted, L'AGREN 's hydrocyclone sand trap is made entirely of hot-dip galvanized steel . This guarantees you a much greater reliability and duration over time.

Hot dip galvanizing compared to other protections :

HOT GALVANIZINGOTHER METALLIC COATINGSPAINTS
Bonded to steelThey do not bind to steelSeparate lining
Very long lifeVariable durationsVariable durations
Electrochemically protectsWithout electrochemical protectionWithout electrochemical protection
Excellent damage resistanceGood damage resistancePoor resistance to damage
Excellent abrasion resistanceGood abrasion resistancePoor resistance to abrasion
Very easy to inspectSometimes difficult to inspectEasy enough to inspect

Dimensions: A = 820mm; B = 400mm; C = 168mm; D = 685mm. (see image below)

hydrocyclone filter

Recensioni

Da il 27 Aug. 2019 (Hydrocyclone filter sand separator cyclone sand separator 3/4 "M) :
(4/5

Recensione positiva

Rapidi , precisi e puntuali. Ci si può senz'altro lavorare, meritano successo.

Accessories

10 other products in the same category: