Hydrocyclone sand separator filter 1/2 "M sand separator
Hydrocyclone sand filter AGREN removes up to 90% of sand and particles greater than 75 μ present in the water of your system.
- Hydrocyclone flow rate: 1.8 m³ / h; 0.5 lt / sec
- Connections: 1/2 "male threaded
- Sand collection tank: 1 "male thread
- Maximum operating pressure: 10 bar
- Resistant and long-lasting thanks to the hot-dip galvanized steel body
HOW TO CHOOSE THE HYDROCYCLONE FOR YOUR SYSTEM
To choose the right hydrocyclone you need to know the pressure and flow rate of the system and the diameter of your pipe.
- The 1/2 "hydrocyclone is the right choice if your system has: at least 1/2 inch pipes, your pump a flow rate of at least 1.8 m³ / h (i.e. 0.5 l / sec or 30 l / min) and a pressure greater than or equal to 2 bar.
- If, on the other hand, you have a system with pipes and a greater flow rate, you can consider the idea of a larger hydrocyclone (3/4 ", 1", ...).
INSTALLATION OF THE HYDROCYCLONE
The hydrocyclone must be connected at the outlet to your pump.
If the pipe diameter is equal to the hydrocyclone just use a 20x1 / 2 "female fitting. If the pipe diameter is greater than 1/2" use a reduction.
WHY BUY A HYDROCYCLONE
The AGREN separator cyclone is suitable for both domestic , agricultural and industrial use and is essential to remove sand and other particles present in the water by separating up to 90% of sand and particles with a grain size greater than 75 μ ( to remove particles below this particle size it is recommended to connect a mesh filter at the outlet of the hydrocyclone )
Advantages for home use :
- you extend the life of your plumbing system by preventing them from messing around: pipes, tap diffusers, boilers, dishwashers and all appliances that use water.
Advantages for irrigation :
- If you draw water from rivers, wells or lakes to irrigate, the particles present can damage or reduce the efficiency of your irrigation system by clogging sprinklers, dripping wings, valves and heads.
OPERATION OF THE HYDROCYCLONE
the centrifugal force of the tangential inlet water separates the sand that slides on the filter wall, precipitating downwards where it is collected in the tank below. To empty the tank, simply open the drain valve. (valve not included).
The centrifugal speed depends on the flow rate and the pressure. The greater the flow rate or pressure of the liquid, the greater the centrifugal force, the more efficient the separator will be.
THE RELIABILITY OF GALVANIZED STEEL
Unlike the products of other brands which are simply painted, L'AGREN 's hydrocyclone sand trap is made entirely of hot-dip galvanized steel . This guarantees you a much greater reliability and duration over time.
Hot dip galvanizing compared to other protections :
|HOT GALVANIZING||OTHER METALLIC COATINGS||PAINTS|
|Bonded to steel||They do not bind to steel||Separate lining|
|Very long life||Variable durations||Variable durations|
|Electrochemically protects||Without electrochemical protection||Without electrochemical protection|
|Excellent damage resistance||Good damage resistance||Poor resistance to damage|
|Excellent abrasion resistance||Good abrasion resistance||Poor resistance to abrasion|
|Very easy to inspect||Sometimes difficult to inspect||Easy enough to inspect|
Dimensions: A = 820mm; B = 400mm; C = 168mm; D = 685mm. (see image below)
- Galvanized steel
- Flow rate
- 1/2" male
- Pressure max
- 10 bar